Page 6 - Regency Spas ~ Hot Tub & Swim Spa Brochure 2019
P. 6
QU ALI T Y ASSU RAN CE
Coast Spas’ quality is the driving force VACUUM FORMING WATER TESTING
behind all of our hot tubs. We are committed We form every hot tub shell using a state- Every hot tub is thoroughly water-tested and
to providing our customers with delivery of of-the-art PlC programmable computer- goes through an 89-point inspection before it
defect-free hot tubs. controlled double-sided vacuum former that leaves the Coast Spas factory.
produces a shell that is seamless, strong,
We are further committed to a company-wide durable and free from blemishes. To prevent any water from freezing in the
programme for continuous improvement pipework, we force out residual water in
targeting perfection. Quality shall, in every BARCOL TESTING pipes after testing by injecting compressed
case, take precedence over quantity. We Barcol test every hot tub shell to ensure air through the pipes.
that the hardness of the fibreglass is greater
than 25 Barcols before we will continue DETAILING
Our vision as a manufacturer is to provide
Hot Tubs that adhere to quality standards manufacturing. This is very important to Each hot tub is detailed by hand and then
recognised all over the world. monitor the state of cure of the resin, to given a careful 74-point inspection before
make sure the shell is supported and is as wrapping to ensure only top quality Hot Tubs
strong as it can be. are being shipped to our customers.
With a global network of 200+ dealers Coast
Spas leads the industry in innovation, design WATER CONSERVATION ENVIRONMENT RESPONSIBILITY
and quality. Water waste is minimised by continuously We sort all material waste consistently for
reusing sanitised clean water in our Hot Tub recycling.
testing facility.
Coast Spas are Built to Last . The result is
®
IN-LINE QUALITY INSPECTIONS the reduction of the use of raw materials and
All hot tubs are quality inspected at each less frequent shipping of products. Operating
stage during the manufacturing process hours in the manufacturing facility are
then water tested to ensure all prior steps consequently reduced, therefore lessening
were properly completed. the impact on the environment.
